Затем таким же образом настроили второй маршрутизатор.

Router>enable            

Router#configure term                    

Enter configuration commands, one per line. End with CNTL/Z.                                                            

Router(config)#int s0/0/0                        

Router(config-if)#ip address 172.16.0.2 255.255.0.0                                                  

Router(config-if)#no shutdown                            

Router(config-if)#                 

*Jan 1 01:52:54.171: %LINK-3-UPDOWN: Interface Serial0/0/0, changed state to do                                                                               

wnexit     

Router(config)#copy run start                            

            ^             

% Invalid input detected at '^' marker.                                      

Router(config)#ip route                      

*Jan 1 01:53:38.551: %LINK-3-UPDOWN: Interface Serial0/0/0, changed state to up                                                                           

*Jan 1 01:53:39.551: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0/                                                                               

0, changed state to up                     

% Incomplete command.                    

Router(config)#int fa0/0                       

Router(config-if)#ip address 192.168.2.1 255.255.255.0                                                     

Router(config-if)#no shutdown                        

Router(config-if)#                 

*Jan 1 01:55:04.343: %LINK-3-UPDOWN: Interface FastEthernet0/0, cha                                                                 

o up   

*Jan 1 01:55:05.343: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthern                                                                               

et0/0, changed state to up                         

*Jan 1 01:55:06.375: %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state t                                                                           

o upexit       

Router(config)#ip route 192.168.1.0 255.255.255.0 172.16.0.1                                                           

Router(config)#exit                  

Router#      

*Jan 1 01:56:14.691: %SYS-5-CONFIG_I: Configured from console by consolecopy ru                                                                               

n start      

Destination filename [startup-config]? startup-config                                                    

Building configuration...                        

[OK]   

Router#show ip route                   

Codes: C - connected, S - static                              

  D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area                                                                    

  N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2                                                                    

  E1 - OSPF external type 1, E2 - OSPF external type 2                                                          

  i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2                                                                           

  ia - IS-IS inter area, * - candidate default, U - per-user static route                                                                             

  o - ODR, P - periodic downloaded static route                                               

Gateway of last resort is not set                                

C 172.16.0.0/16 is directly connected, Serial0/0/0                                                    

S 192.168.1.0/24 [1/0] via 172.16.0.1                                   

C 192.168.2.0/24 is directly connected, FastEthernet0/0                                                         

Router#ping          

Protocol [ip]: ping 192.168.1.0                              

% Unknown protocol - "ping 192.168.1.0", type "ping ?" for help                                                              

Router#ping 192.168.1.0                      

Type escape sequence to abort.                             

Sending 5, 100-byte ICMP Echos to 192.168.1.0, timeout is 2 seconds:                                                                   

!!!!!    

Success rate is 100 percent (5/5), round-trip min/avg/max = 32/32/32 ms       

Затем произвели настройку динамической маршрутизации с использованием протокола RIPv1.  Для первого маршрутизатора:

Router#conf term               

Enter configuration commands, one per line. End with CNTL/Z.                                                            

Router(config)#no ip route 192.168.2.0 255.255.255.0 172.16.0.2                                                              

Router(config)#^Z                

Router#      

*Nov 15 08:08:47.439: %SYS-5-CONFIG_I: Configur                                            

 route     

Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP                                                             

  D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area                                                                

  N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2                                                                    

  E1 - OSPF external type 1, E2 - OSPF external type 2                                                      

  i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2                                                                           

  ia - IS-IS inter area, * - candidate default, U - per-user static route                                                                             

  o - ODR, P - periodic downloaded static route                                                   

Gateway of last resort is not set                                

C 172.16.0.0/16 is directly connected, Serial0/0/0                                                    

C 192.168.1.0/24 is directly connected, FastEthernet0/0                                                     

Router#conf term               

Enter configuration commands, one per line. End with CNTL/Z.                                                            

Router(config)#router rip                        

Router(config-router)#network 172.16.0.0                                       

Router(config-router)#network 192.168.1.0                                        

Router(config-router)#show ip route                                  

                 ^                  

% Invalid input detected at '^' marker.                                      

Router(config-router)#^Z                       

Router#      

*Nov 15 08:10:50.047: %SYS-5-CONFIG_I: Configured from console by consolesho\                                                                            

% Unknown command or computer name, or unable to find computer address                                                                     

Router#show ip route               

Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP                                                             

  D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area                                                                

  N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2                                                                    

  E1 - OSPF external type 1, E2 - OSPF external type 2                                                      

  i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2                                                                           

  ia - IS-IS inter area, * - candidate default, U - per-user static route                                                                         

  o - ODR, P - periodic downloaded static route                                                   

Gateway of last resort is not set                                

C 172.16.0.0/16 is directly connected, Serial0/0/0                          

C 192.168.1.0/24 is directly connected, FastEthernet0/0

Router#conf term

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#router rip

Router(config-router)#network 172.16.0.0

Router(config-router)#network 192.168.1.0

Router(config-router)#^Z

Router#

*Nov 15 08:13:14.663: %SYS-5-CONFIG_I: Configured from console by consoleshow ip

 route

Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP

  D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area

  N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2

  E1 - OSPF external type 1, E2 - OSPF external type 2

  i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2

  ia - IS-IS inter area, * - candidate default, U - per-user static route

  o - ODR, P - periodic downloaded static route

Gateway of last resort is not set

C 172.16.0.0/16 is directly connected, Serial0/0/0

C 192.168.1.0/24 is directly connected, FastEthernet0/0

R 192.168.2.0/24 [120/1] via 172.16.0.2, 00:00:02, Serial0/0/0

Для второго маршрутизатора:

Router(config)#no ip route 192.168.1.0 255.255.255.0 172.16.0.1 IS-IS level-1, L2 - IS-IS level-2                            

Router(config)#exit                  

Router#

*Jan 1 02:02:47.111: %SYS-5-CONFIG_I: Configured from cons                                                         

  N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2nal, O - OSPF, IA - OSPF inter area                                 

  E1 - OSPF external type 1, E2 - OSPF external type 2ternal type 1, N2 - OSPF NSSA external type 2             

  i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2rnal type 1, E2 - OSPF external type 2                                     

  ia - IS-IS inter area, * - candidate default, U - per-user static route L2 - IS-IS level-2                                                      

  o - ODR, P - periodic downloaded static routeandidate default, U - per-user s                   

Gateway of last resort                     

G

C 192.168.2.0/24 is directly connected, FastEthernet0/0     

Router#en        

Router#show int brief         

Router#rip

Translating "rip"...domain server (255.255.255.255) at '^' marker.                                   

Translating "rip"...domain server (255.255.255.255)NK-3-UPDOWN: Interface Serial0/0/0, changed state t

 (255.255.255.255)                 

Translating "rip"...domain server (255.255.255.255)v 15 07:32:54.703: %LINEPROTO-5-UPDOWN: Line protoc

% Unknown command or computer name, or unable to find computer address         

Router#

Router#conf term

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#router rip

Router(config-router)#network 172.16.0.0

Router(config-router)#network 192.168.2.0

Router(config-router)#^Z

Router#

*Jan 1 02:05:54.543: %SYS-5-CONFIG_I: Configured from console by consoleshow ip

 route

Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP

  D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area

  N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2

  E1 - OSPF external type 1, E2 - OSPF external type 2

  i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2

  ia - IS-IS inter area, * - candidate default, U - per-user static route

  o - ODR, P - periodic downloaded static route

Gateway of last resort is not set

C 172.16.0.0/16 is directly connected, Serial0/0/0

R 192.168.1.0/24 [120/1] via 172.16.0.1, 00:00:09, Serial0/0/0

C 192.168.2.0/24 is directly connected, FastEthernet0/0

Вывод: В ходе данной лабораторной работы мы изучили принципы работы маршрутизатора и произвели настройку статической и динамической маршрутизации.